< Back to IRCAM Forum

MIDI setup problems in OM 6.9

OpenMusic
#61

Pour ma part je suis sur Mountain Lion et OM 6.9 et tout marche parfaitement à ce niveau.
Ceci étant personne ne semble évoquer ce problème sur ElCapitan il s’agit donc sûrement d’un mauvais setup.
Essayez le monitor MIDI.

#62

Have you try this :

http://notahat.com/simplesynth/

works with OM 6.10

……………………………………………………… jerome

NB : Launch it before launching OM for being recognized by OM

#63

@adkaplan : Oui, il faut installer un synthétiseur MIDI qui va recevoir les commandes MIDI envoyées par OM
Vous pouvez utiliser par exemple SimpleSynth qui est très facile : notahat.com/simplesynth/

#64

A choisir dans l’onglet MIDI des preférences d’OM

#65

Thank’s problem resolved. The error message disappeared and I was able to reach the Microsoft GS Wavetable Synth

#66

Hi all,

I’m running OM6.10 on OSX and I can’t seem to get any sound. I’ve tried to follow everything in this thread but I have this same message since the beginning:
OM > Warning: player engine :midishare not available for #<chord-seq 414011E533> (will be played on :midi-player).

There’s no sound though. What should I do?

Thank you!

#67

This message appears because your chord-seq box was set on the :midishare player, which has been removed from OM 6.10 (and replaced with an in-built :midi-player)
Basically, it is nothing bad :slight_smile:
You can remove it by setting the player once for all (from inside the editor or using right-click => Player on the chord-seq box).
That will probably not change the sound (or no-sound) result.

You should maybe check that at least one synthesizer is connected to the default port (0) in the MIDI Preferences ? What are you using for rendering ?
(ps. did you read this as well? : http://repmus.ircam.fr/openmusic/midi)

#68

Thank you, Jean!
I’ve done as you mentioned and the message doesn’t appear anymore. However there is still no sound…
My input device in port 0 is IAC Driver Bus 1, and my output device in port 0 is SimpleSynth. Any suggestions?
Thank you so much!

#69

Hi,

Just check out SimpleSynth’s panel and choose the correct port (you may choose either one of simplesynth or IAC).
And don’t use the same port for input and output.

Best
K

#70

Hi Karim,

Thank you! It works now! Woohoo!

Best wishes
D

#71

Hi Karim,

Thank you! It works now! Woohoo!

Best wishes
D